Preparation and physicochemical properties of the Fe, Mn-oxides catalyst
https://doi.org/10.29235/1561-8323-2021-65-1-46-51
Abstract
A Fe, Mn-oxide catalyst was obtained by impregnation of thermally activated dolomite granules with aqueous solutions of Fe(III) and Mn(II) sulfates followed by heat treatment. Its physicochemical properties were studied using differential thermal analysis, X-ray diffraction, low-temperature adsorption-desorption of nitrogen, and scanning electron microscopy. The high efficiency of Fe(II) ion oxidation in aqueous media in a flow-type catalytic reactor was shown, which makes the obtained catalyst promising for the deironization of artesian waters.
About the Author
A. I. Ivanets
Institute of General and Inorganic Chemistry of the National Academy of Sciences of Belarus
Belarus
Belarus
Ivanets Andrei I. – D. Sc. (Chemistry), Associate professor, Leading researcher
9/1, Surganov Str., 220072, Minsk
References
1. Han D., Currell M. J., Cao G. Deep challenges for China’s war on water pollution. Environmental Pollution, 2016, vol. 218, pp. 1222–1233. https://doi.org/10.1016/j.envpol.2016.08.078
2. Patel A., Shah A. Sustainable solution for lake water purification in rural and urban areas. Materials Today: Proceedings, 2020, vol. 32, pp. 740–745. https://doi.org/10.1016/j.matpr.2020.03.473
3. Choudhary R., Gupta R., Nagar R., Jain A. Sorptivity characteristics of high strength self-consolidating concrete produced by marble waste powder, fly ash, and micro silica. Materials Today: Proceedings, 2020, vol. 32, pp. 531–535. https://doi.org/10.1016/j.matpr.2020.01.287
4. Patil D. S., Chavan S. M., Kennedy Oubagaranadin J. U. A review of technologies for manganese removal from wastewaters. Journal of Environmental Chemical Engineering, 2016, vol. 4, no. 1, pp. 468–487. https://doi.org/10.1016/j.jece.2015.11.028
5. Outram J. G., Couperthwaite S. G., Millar G. J. Comparative analysis of the physical, chemical and structural characteristics and performance of manganese greensands. Journal of Water Process Engineering, 2016, vol. 13, pp. 16–26. https://doi.org/10.1016/j.jwpe.2016.07.006
6. Rat’ko A. I., Ivanets A. I., Voronets E. A. Copper-Magnesium Oxide Catalyst Based on Modified Dolomite. Russian Journal of Applied Chemistry, 2012, vol. 85, no. 6, pp. 856−861. https://doi.org/10.1134/s1070427212060031
7. Ivanets A. I., Rat’ko A. I., Kuznetsova T. F., Voronets E. A. Effect of Heat Treatment on the Physicochemical Properties of Cu- and Mn-Containing Oxide Catalysts. Inorganic Materials, 2012, vol. 48, no. 9, pp. 908–913. https://doi.org/10.1134/s0020168512090075
8. Ivanets A. I., Kuznetsova T. F., Voronets E. A. Chapter 6: Manganese and Copper Oxide Catalysts Deposited on Dolomite Substrate For Groundwater Purification. Dolomite: Formation, Characteristics and Environmental Impact. New York, 2017, pp. 159–186.
9. Amiri M., Eskandari K., Salavati-Niasari M. Magnetically retrievable ferrite nanoparticles in the catalysis application. Advances in Colloid and Interface Science, 2019, vol. 271, art. 101982. https://doi.org/10.1016/j.cis.2019.07.003
10. Elmaci G., Ozer D., Zumreoglu-Karan B. Liquid phase aerobic oxidation of benzyl alcohol by using manganese ferrite supported-manganese oxide nanocomposite catalyst. Catalysis Communications, 2017, vol. 89, pp. 56–59. https://doi.org/10.1016/j.catcom.2016.10.027
11. Thommes M., Kaneko K., Neimark A. V., Olivier J. P., Rodriguez-Reinoso F., Rouquero J., Sing K. S. W. Physisorption of Gases, with Special Reference to the Evaluation of Surface Area and Pore Size Distribution (IUPAC Technical Report). Pure and Applied Chemistry, 2015, vol. 87, no. 9–10, pp. 1051–1069. https://doi.org/10.1515/pac-2014-1117
Review
Views: 662
Email this article 